Mounting and Setup
Hanging your Ringo
- Measure 56” (Adult) or 48” (Family) up a flat surface and insect one of the provided screws so that it extends out about ¼”.
- Position your Ringo board over the screw and insert it into the “key hole”. Reposition the screw and repeat if necessary until your Ringo Board fits tightly against the surface.
- Extend the arm out to 90-degree to reveal the mounting hole located in the center of the hinge.
- Use the second screw to finish mounting your Ringo Board to the surface. Use a level if necessary (available as a free app on most phones if you don’t have one)
- Lock the arm in place by fitting the 45-degree support into the notch on the main board. This is designed to fit tightly to create the proper support. Press the support arm with your palm while gently lifting on the arm until it fits into place. It will make a clicking noise when properly inserted.
- To lower the arm when not in use, lift gently with your thumb at the end of the arm (in front of the rope holes) while removing the support from its seated position with your other hand
Rope Assembly
- After your Ringo Board has been mounted; extend the arm and lock it in place.
- Feed the free end of the rope through one end of the included rope stopper.
- Feed the rope up through first hole located at the end of the arm (hole closest to player) and back down the second hole.
- Feed the end of the rope through the second hole of the rope stopper leaving approximately four inches of rope remaining. Tie a loose knot for a clean finish.
- Adjust the stopper so that it fits tightly up against the bottom of the arm and thesis no slack on the top of the arm.
- When the ring is balanced on the hook, it should be parallel to the Ground with very little slack in the rope. Adjust as necessary.
